mounting technique

2015/5/23 11:42:57

1. Note: in barrels of quick connector should again and soak in warm water. ,
2. Will the top of the quick joint, and press the palms of escaping again with your thumb and forefinger, middle finger to pull down to the bottom of the quick joint place, and then set into the syrup barrels, under the pressure.
3. How to unload will check the pressure of rapid joint hand up again with his thumb and forefinger, middle finger to pull down to the bottom of the quick joint place, then take up.
4. White joint department IN into carbon dioxide. Black connector is OUT of syrup. Such as syrup on the barrel is not marked OUT IN syrup on barrel along the rubber have small grooves for filling IN.
5. If the quick joint did not soaked in advance, the rubber band on the valve on the grinding mark, will lead to leakage of syrup or carbon dioxide.